ZigUNO is a development board for creating DIY Zigbee devices based on Ebyte E18-MS1 module (CC2530)

Physically, the board is compatible with all shields of the Uno form factor. Finally you can use countless old Arduino shields 🤣

As a firmware, it is proposed to use:

  1. Zigbee configurable firmware PTVO 🚀
  2. Develop your own using ZigUP or one of the various DIYRuZ projects as examples
  • A beginner’s guide to using PTVO is available on Habr (in russian)
  • A beginner’s guide to developing your own Zigbee firmware is available on Habr (in russian)
  • A complete guide showing how to install IAR to start developing your own firmware is available on ZigDevWiki
OSHWA UID UA000001
ZigUNO is certified open source hardware project

Overview

v1.5 (Jun 2022)

Version 1.5 differences:

  • Type C instead of micro usb, keeping up with the times 🤩
  • The 8-pin connector has been replaced with a 6-pin connector. the last two are not connected and only interfere with some sub-boards 🤦‍♂️
  • Rearranged components on the board 🙃
  • Added designations of pin capabilities directly to the board to make it even more convenient for you 🥳
  • Slightly changed the graphics on the board, as a sign of support for Ukraine 🇺🇦

Scheme is the same. Gerber files will be uploaded after the tests. Photo too.

v1.0

Pinout

Photos

Schematic

Gerber & BOM

Gerber
BOM

Where to buy?

I sell on Tindie

Go to mind.in.ua

Like ♥️?

“Buy Me A Coffee”


Made in Ukraine


ZigUNO is licensed under the

GNU General Public License v3.0