About

Zigbee based 6ch DC power meter E18-MS1-PA2, 2xINA3221, SHTC3 0 - 26V, 8mV resolution +/- 5.2A, 1.3mA resolution

Overview

Schematic

PDF
Schematic

Where to buy?

I sell on Tindie

Firmware

PTVO firmware constructor was used to build the firmware. There are two versions:

  • Router - Supports routing but doesn’t report the uptime of the device. hex 🔵 txt
  • End Device - No router functions, no SHTC3 sensor (temperature & humidity), but reports the uptime of the device. hex 🟠 txt

Use PTVO version 2024-01-04 because newer version use different clusters and don’t support 3 channels on 1 endpoint.

Support

Currently only supports in zigbee2mqtt. (Without external converter)

DIY

This work is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License

Like ♥️?

badges badges badges